Wej It Fastening Systems
PRODUCTS
FAQ

  Sales: 888-864-4537
  Fax: 203- 857-2201
  Email: info@wejit.com

Wej-Con Concrete Screws



Installation Instructions
  • It is recommended that a minimum of 1" and a maximum of 1-3/4" embedment be used in determining fastener length.
  • The correct hole depth (B & C) can normally be obtained by drilling the full length of Wej-it® carbide-tipped drill bit supplied with each box of Wej-Con fasteners. In all cases, the hole must be at least 1/4" deeper than the depth of the fastener embedment.
  • Normal safety precautions should be observed when drilling the holes to avoid electrical installations, other utilities and reinforcement bars.


©2002-2012 The Mechanical Plastics Corp., all rights reserved.
® & denote trademarks owned by or licensed to Mechanical Plastics Corp., its affiliates, or partners. | Legal