Wej It Fastening Systems
PRODUCTS
FAQ

  Sales: 888-864-4537
  Fax: 203- 857-2201
  Email: info@wejit.com

Sleeve-TITE Sleeve Anchors



Installation Instructions
  1. Drill the hole perpendicular to the work surface. To assure full holding power, do not ream the hole or allow the drill to wobble.
  2. Drill the hole deeper than the intended embedment of the anchor, but not closer than two anchor diameters to the bottom (opposite) surface of the concrete. Through drilling is allowed when using sleeve anchors in hollow concrete block.
  3. Clean the hole using compressed air and a nylon brush. A clean hole is necessary for proper performance.
  4. Assemble the washer and nut on the anchor so that the nut protrudes slightly beyond the fixture and insert anchor into the hole making sure the nut, or head, rests solidly against the fixture.
  5. Tighten the nut, or head, 3 to 5 turns past the hand tight position.

NOTE: Always wear safety glasses. Follow drill manufacturer's instructions. Use only solid carbide-tipped drill bits meeting ANSI B212.15 diameter standards.



©2002-2012 The Mechanical Plastics Corp., all rights reserved.
® & denote trademarks owned by or licensed to Mechanical Plastics Corp., its affiliates, or partners. | Legal