Wej It Fastening Systems
PRODUCTS
FAQ

  Sales: 888-864-4537
  Fax: 203- 857-2201
  Email: info@wejit.com

Slam-It™ Split Drive Anchors



Installation Instructions
  1. Drill hole in masonry or concrete through mounting holes in fixture same diameter as anchor to be used. Clean hole using compressed air and a nylon brush. A clean hole is necessary for proper performance.

  2. Insert anchor through mounting holes in fixture and into anchor hole.

  3. Tap gently until head of anchor body is set tightly against item to be fastened. Gently hammer pin flush to expand body. Do not over-drive pin into body as this could damage the anchor.


©2002-2012 The Mechanical Plastics Corp., all rights reserved.
® & denote trademarks owned by or licensed to Mechanical Plastics Corp., its affiliates, or partners. | Legal