Wej It Fastening Systems
PRODUCTS
FAQ

  Sales: 888-864-4537
  Fax: 203- 857-2201
  Email: info@wejit.com



lag screw instructions


Installation Instructions
  1. Drill the hole according to the "Drill Dia." shown on the Performance Data Chart on the Tech Specs tab. To assure full holding power, do not ream the hole or allow the drill to wobble.
  2. Drill the hole deeper than the intended embedment, but not closer than two diameters to the bottom (opposite) surface of the concrete.
  3. Clean the hole with a nylon brush and compressed air.
  4. Insert anchor into the hole and tap flush.
  5. Position fixture, insert bolt and tighten.
NOTE: Always wear safety glasses. Follow drill manufacturer's instructions. Use only solid carbide-tipped drill bits meeting ANSI B212.15 diameter standards.


©2002-2012 The Mechanical Plastics Corp., all rights reserved.
® & denote trademarks owned by or licensed to Mechanical Plastics Corp., its affiliates, or partners. | Legal