Wej It Fastening Systems
PRODUCTS
FAQ

  Sales: 888-864-4537
  Fax: 203- 857-2201
  Email: info@wejit.com





Installation Instructions
  1. Drill the hole, whose diameter equals the anchor diameter, perpendicular to the work surface. To assure full holding power, do not ream the hole or allow the drill to wobble.
  2. Drill the hole deeper than the intended embedment, but not closer than two diameters to the opposite surface of the concrete.
  3. A clean hole is necessary for proper performance. Clean the hole using a nylon brush and compressed air.
  4. Assemble the nut and washer so that the top of the nut is flush with the top of the anchor. Drive the anchor through the material to be fastened so that the nut and washer are flush with the surface of the material.
  5. Tighten the nut, or head, 3 to 5 turns past the hand tight position. Installing the "Ankr-TITE® Series" of anchors with a torque wrench is recommended for optimum performance. Refer to adjacent chart.*
NOTE: Always wear safety glasses. Follow drill manufacturer's instructions. Use only solid carbide-tipped drill bits meeting ANSI B212.15 diameter standards.





©2002-2012 The Mechanical Plastics Corp., all rights reserved.
® & denote trademarks owned by or licensed to Mechanical Plastics Corp., its affiliates, or partners. | Legal