Sales: 888-864-4537
Fax: 203- 857-2201
Email: info@wejit.com
|

|

Installation Instructions
- Drill the hole, at a diameter equal to the
anchor diameter, perpendicular to the work
surface. To assure full holding power, do not
ream the hole or allow the drill to wobble.
- Drill the hole deeper than the intended
embedment, but not closer than two
diameters to the bottom (opposite) surface
of the concrete.
- A clean hole is necessary for proper
performance. Clean the hole using a nylon
brush and compressed air.
- Assemble the nut and washer so that the top
of the anchor extends above the nut slightly.
Install the anchor through the material to be
fastened.
- Installing the Ankr-TITE CCAT anchors
with a torque wrench is recommended for
optimum performance. Refer to torque
recommendations on this page.
NOTE: Always wear safety glasses. Follow drill manufacturer's instructions. Use only solid carbide-tipped drill bits meeting ANSI B212.15 diameter standards.
|

|

©2002-2012 The Mechanical Plastics Corp., all rights reserved. ® &™ denote trademarks owned by or licensed to Mechanical Plastics Corp., its affiliates, or partners. |
Legal
|