Drill a 1/2" (Ø13mm) hole. Hold metal channel flat alongside plastic straps and slide channel through hole. Minimum clearance behind wall: 1-7/8" (48mm).

Hold ends of straps between thumb and forefinger and pull toward you until channel rests flush behind wall. Slide plastic cap along straps with other hand until flange of cap is flush with wall.

Snap straps at wall by pushing side to side, snapping off straps level with flange of cap.

Place item over flange. Insert bolt through item and tighten until flush against item, then stop.

Use machine screw or bolt to match thread in channel: BA (3/16"-24), BB (1/4"-20), BM5 (M5), and BM6 (M6).
Bolt length = item thickness + wall or ceiling thickness + 1/2" (13mm)

Also available for larger bolt sizes: BE (5/16"-18), BC (3/8"-16), BD (1/2"-13), BM8 (M8), and BM10 (M10). These anchors require a 3/4" (Ø19mm) hole and have a grip range of 3/8" to 2-1/2".

> How-To Installation
> Ask the Expert Q&A

Technical Bulletin
> Downloadable PDF
> View Specific Catalog Info

SNAPTOGGLE vs. Competition
> Downloadable PDF

Exceeds Building Code Requirement!
Most national and local building codes require that grab bars be able to sustain 250 pounds of dead load force. The BB 1/4"-20 SNAPTOGGLE Toggle Bolt substantially exceeded that requirement, holding 360 pounds in 1/2" drywall in tests conducted by the Cornell University / Joan and Sanford I. Weill Medical College / Gerontological Environmental Modifications unit and the Eastern Paralyzed Veteran's Association in the EPVA's lab in Fort Totten, New York, in April 2002.

The SNAPTOGGLE Toggle Bolt [called the "Toggler Bolt" in these tests] was the only anchor that met this requirement when tested in drywall alone! See the test results here: www.environmentalgeriatrics.com

SNAPTOGGLE Applications/Solutions
> Shelving
> Bathroom Accessories
> Flat Screen TVs (LCD and Plasma)
> Draperies, Curtain Rods, and Blinds
> Mirrors