Specialty Anchors - Shelving

Specialty Anchors - Shelving Packaging

No More Fumbling with Shelving Standards

The built-in spacer is made to fit flush with shelving standards (C-channel) to ensure accurate alignment and to prevent the anchor from being jacked out of the wall during installation.

May be also used as a stand-off for installing equipment on warm or wet walls when ventilation is needed behind the installed object.

Part number 50260 = Bag of 7 TBS1 TOGGLER Shelving Anchors, 7 #8 x 1-3/4" combo head screws & 1 setting key.
Part number 11023 = Box of 50 TBS1 TOGGLER Shelving Anchors & 3 setting keys


Position standard on wall and hang it loosely by a nail from top screw hole. (Gravity will hold standard straight.) Mark the remaining screw hole locations. Remove nail and standard.

Shelving Installation Image 1

Drill a 5/16" diameter hole at each mark—minimum hole depth in solid walls 1-1/4+. Fold anchor, insert in hole, and tap flush with wall.

Shelving Installation Image 2

Insert black key to pop anchor open behind wall (except in thick or solid walls). DO NOT HAMMER KEY. Remove key.

Shelving Installation Image 3

Place standard over anchors. Insert screws and tighten until flush with standard—then stop.

Use enclosed screws or any #7 x 1-3/4" flat head screw.

Shelving Installation Image 4

The anchors also wedge securely in thick and solid walls. Do NOT use key.

Position and install additional standards on wall, leveling top of each with top of first standard.

For double-slotted standards, use TOGGLER® Pegboard Anchors TBS2.


TOGGLER Specialty Anchors can be used in almost any material, including:

  • Gypsum Board
  • Drywall
  • Plasterboard
  • Plaster
  • Accoustic Ceilings
  • Tile over drywall

All TOGGLER Specialty Anchors can be used in any material (concrete, plywood, paneling, drywall, etc.) of any thickness above their minimum grip range.

All TOGGLER Specialty Anchors install in the wall like our TOGGLER Hollow-Wall Anchors, and wedge securely even if you hit a cavity in the wall with your drill. Each requires only a 5/16" (ø8mm) diameter drill bit.

Additional Information

Technical Bulletin
> Downloadable PDF

Shelving Applications/Solutions
> Shelving